FDJ Centrifugal 5/8 Clutch 11 Tooth Mini Bike Clutch With Predator Engine Go Kart Clutch Bolt And Washers Kit

COMPATIBLE Go Kart Clutch 3/4 Bore 12T for 35 Chain, Perfect for Go Kart, Minibike and Fun Kart Engine 3/4 Bar Centrifugal Clutch Fits Honda GX160, GX200, GX 140, GX120, GC160, GC190, Harbor Freight Greyhound 196cc, Harbor Freight Predator 212cc, Briggs and Stratton Tecumseh Engines 2-6.5 HP with 3/4” shaft Fit Centrifical Tecumseh Engines 2 - 6.5 HP with 3/4 Shaft and Any Other Go Cart Motor Auto Engines with 3/4 Crank Shaft and 3/16 Key Way How Do You Install A New Clutch on A Go Kart? ASSEMBLY INSTRUCTIONS: Remove outer drive cover. Loosen nuts on bottom of engine mounting plate allowing engine to slide back,loosening drive chain. Remove drive chain from drive wheel sprocket(axle sprocket). Remove bolt and washers from end of engine crankshaft while noting location of spacers and washers for installing new clutch. Remove clutch from engine crankshaft. Install new clutch by aligning key inbore of clutch with keyway in engine crankshaft. Slide clutch onto shaft. Reinstall bolt and washers that hold clutch on crankshaft. Tightenbolt. Reinstall drive chain on clutch and drive wheel sprocket(axlesprocket). Slide engine forward to tighten chain. Chain should have approximately 1/4 deflection when properly tensioned. Tighten nuts on bottom of engine mounting plate. Reinstall outer drive cover. WARNING! Guards must be inplace to protect rider(s) from rotating parts. There's an internal bronze bushing behind the snap ring that requires lubrication and it's up to you to put it there each time. It's a good idea to oil the chain at the same time. If the chain gets kinky from lack of oil it should be replaced before it damages the clutch sprocket. A new chain is cheaper than a new clutch. Do not lubricate the ventilation holes of the clutch, as this will only cause the clutch to slip and not fully engage anymore. Removal of the bushing from the sprocket is the best way to ensure proper lubrication. Inspect the clutch for damaged, missing, or loose parts. So the true motive is that the ratio just isn’t steep sufficient, and subsequently, the engine smokes the clutch. The treatment for the primary clutch smoking drawback is to change the driveline in order that the general ratio is steeper. The easy technique is to extend the rear sprocket diameter. So the clutch engagement rpm must be taken under consideration in any other case the clutch will smoke on the secondary jackshaft mounting place. No larger than 15 tall.5. Weight: A centrifugal clutch is designed to be able to move a certain amount of weight. 6. Gear ratio: The sprocket on the engine and the one on the rear axle should have a ratio close to 1:6.(10 tooth = 60 rear sprocket)7. Restrictions: Don't try and reduce a go kart speed by limiting the travel of the gas pedal or by putting a restrictor in the carburetor to limit full rpm. 8. Don't put oil inside the clutch holes: The holes on the drum are to let the hot air out of the clutch. Go Kart Clutch 3/4 Bore 12T for 35 Chain, Perfect for Go Kart, Minibike and Fun Kart Engine 3/4 Bar Double Protection: Predator Engine Go Kart Clutch Bolt,Washer,Screws and Allen Wrench are All Included.